The first dig will involve going down to the shelf level. Once you have enough turf saved, you can begin going all out and digging the hole. You don't need to save all of the turf, just enough to cover your tracks. Once you have your frame built and an area marked off, you can begin taking off some of the turf so that you can use it to backfill later. You may want to add about 2-5 inches to the outline of the frame so that it will be easier to place it in the hole. You can do this with one person, but it will go by faster with two.Īfter the frame is set up, find a way to mark the area that you want to start digging (can use spray paint). Make sure that the holes for the springs are pointing upwards when you are doing so. You do not need to assemble it completely, you just need to get it to where you are able to mark the dig area.īegin assembling it in the area you plan to dig the hole. Step One: Set Up the Frame and Mark the Dig Area Step Three: Finish the Frame and place it in the hole.Step One: Set Up the Frame and Mark the Dig Area.Installing an in-ground trampoline step-by-step: Also keep in mind that it's a good idea to do some form of water mitigation through drainage. Check off everything that you need and get everything organized in the yard so that it is readily available. Remember that this document is only meant to serve as a guide, and not to fully replace the manual that you should have received along with an in ground trampoline.īefore you start assembling and installing the in-ground trampoline kit, un-package everything and open up the manual to make sure you have all the parts required. Looking for directions on how to install an in ground trampoline? If your trampoline has arrived and you are ready to install it, then you can use this guide to help you along the way.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |